AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Laundry machine drum10/7/2023 It is designed to allow the tub to get up to the proper spin speed gradually. The clutch assembly makes the connection between the transmission and the inner tub. If the washer is making a loud noise in the spin cycle, the clutch assembly might be worn out. It is designed to fail if the washer is overloaded in order to protect both the motor and transmission. The motor coupling connects the motor to the washer transmission. If the washer is making a loud noise the motor coupling might have failed. Although this is not a very difficult repair for a DIY'er with some experience, the part is expensive and so it may be worth considering a new washer. This is the primary drive mechanism for the agitation motion in this washer. If the washer is making a loud noise the U-Joint may have failed. If the drive pulley is loose or wobbling it will need to be replaced If the washer is making a loud noise the drive pulley may be worn out. If it is damaged or defective replace it. Remove the drive pulley and inspect it carefully. If the washer is making a loud noise the drive pulley might be worn out, cracked, loose or bent. However, the problem is going to get worse very quickly and so either the drum and bearing will need to be replaced or the washing machine. This is a very involved repair and will require disassembling most of the washer. On this washer the bearing might not be sold separately, the entire rear drum might have to be replaced. If the washer is making a loud noise the rear drum with bearing might need to be replace. If the bearing is bad the problem is going to get worse very quickly and so either the tub seal and bearing kit will need to be replaced or the washing machine. If the washer is making loud noise the tub seal and bearing kit might need to be replace. If the bearing is bad the problem is going to get worse very quickly and so either the drum and bearing will need to be replaced or the washing machine. ![]() The manufacturer recommends that if possible the complete outer tub and bearing be replaced rather than attempting to replace just the bearing in the tub. If the washer is making a loud noise the tub bearing might need to be replace. If you give us the model number I can probably find the part. My bet would be the Pulley or Drive Pulley.
0 Comments
Read More
Leave a Reply. |